GR2 Zoning Cape Town: Coverage, Height and Building Lines Explained
GR2 lets you build flats and denser housing than a normal house zone, but the label alone does not tell you the coverage, height or building lines that decide what fits. Here is what GR2 means, in plain English.
If your erf is zoned GR2, which is General Residential Subzoning 2, the City's map will show you that label and stop there. It will not tell you how much of the erf you can cover, how tall you can build, or how close to the boundary you can go. Those numbers decide whether a block of flats or a boarding house fits on your site. A house or a group housing scheme follows different rules, explained below.
For the bigger picture beyond one zone, our guide to zoning reports in South Africa shows how zoning, building lines and title deed conditions fit together. If you are not sure what your zoning is, start with the free zoning check.
Free property check
Check what your property is zoned
Enter the address or erf number to confirm your zoning before you rely on a general guide like this one.
The short answer
- GR2 is the lowest of the five General Residential subzonings for flats, GR2 to GR6. (GR1, General Residential Subzoning 1, is for group housing.) It allows flats, at a smaller scale than GR3 to GR6.
- For flats, boarding houses and hotels, coverage is 60% of the erf. The floor factor is 1,0. The maximum height is 15,0 m above existing ground level.
- For those same uses, the street building line is 4,5 m. The side and rear (common boundary) building line is 4,5 m or 0,6 times the height of the point you are measuring, whichever is greater. There is one concession, explained below.
- Flats, group housing, boarding houses, guest houses and second and third dwellings are all primary uses. The land use itself does not need consent, but the development rules still apply.
- A house, a second dwelling or a third dwelling on a GR2 erf does not get these figures. It follows the rules for a house in R1 (the zone older records call SR1). Group housing follows the group housing rules of GR1 instead. More on both below.
The tables and numbers on this page come from the City's Municipal Planning By-Law, as amended with effect from 1 October 2025, plus the 2026 amendment on the rear boundary described below. Always confirm them against your own erf, because overlays and special conditions can change what applies.
What GR2 means
GR2 sits at the bottom of the GR2 to GR6 ladder. The five subzonings allow similar uses, such as dwellings, flats and group housing. For flats, boarding houses and hotels, what changes from one subzoning to the next is how much floor area and height you get.
| Subzoning | Coverage | Floor factor | Maximum height |
|---|---|---|---|
| GR2 | 60% | 1,0 | 15,0 m |
| GR3 | 60% | 1,25 | 20,0 m |
| GR4 | 60% | 1,5 | 24,0 m |
| GR5 | 60% | 2,5 | 35,0 m |
| GR6 | 60% | 5,0 | 50,0 m |
Coverage is the same 60% in all five. The floor factor is what separates them. It limits the total floor area of all your buildings, compared with the size of the erf. A footprint that is allowed on both a GR2 and a GR6 erf can end up as a very different building once the floor factor and height limit are applied.
A simple way to see it: on a 1 000 m² GR2 erf you may cover 600 m², but the floor factor of 1,0 caps the total floor area at 1 000 m². That is under two full storeys at the maximum footprint. Plenty of concept designs get drawn against the coverage figure alone and have to lose a floor later.
Building lines on GR2
For flats, boarding houses and hotels, the street building line is 4,5 m. For the side and rear boundaries the line is 4,5 m or 0,6 H, whichever is greater. H is the height, in metres, of the point of the building you are measuring above the ground floor. So the higher the wall, the further back it has to sit.
There is one concession. Where a common boundary meets a street boundary, a building up to 15,0 m high may go right up to that boundary (0,0 m) for the first 18,0 m measured back from the street. Beyond that distance, the 4,5 m or 0,6 H line applies again. Note that the 15,0 m here is the height of the building, not the distance from the street.
The City's 2026 amendment, in force since 11 September 2026, adds one limit to this. The 4,5 m or 0,6 H line always applies along the rear boundary, which is the boundary at the back of the erf, usually opposite the street. That holds even when the rear boundary is closer than 18,0 m to the street. The concession does not reach it.
An outbuilding may sit inside the common boundary building line if it is no higher than 3,5 m.
A house or group housing on a GR2 erf
This surprises many owners. The 60%, 1,0 and 15,0 m figures are for flats, boarding houses and hotels (item 41 of the by-law). They are not for a house.
If you are building a single dwelling house on a GR2 erf, the rules for a house in R1 apply. The same goes for a second dwelling, and for a third dwelling. In the by-law, items 21(b) and 22 (the R1 rules) apply to a dwelling house in GR2, items 21(b), 22 and 25A apply to a second dwelling, and item 25B applies to a third dwelling (item 42).
Group housing is different again. Item 43 sends group housing on GR2 to the group housing rules of GR1, so look at those, not at the GR2 table.
So if you own a house on a GR2 erf and want to extend it, check the R1 rules for your erf size. Our SR1 guide and our guide to building an extension in Cape Town are the place to start.
What you can build on GR2
The primary uses are a dwelling house, second dwelling, third dwelling, group housing, boarding house, guest house, flats, a private road, and a few small energy and charging uses. Additional use rights include a home occupation, a supplementary dwelling unit and a small-scale wind turbine.
Consent uses need council approval even though the zoning allows them in principle. They include a place of instruction or worship, an institution, a hospital, a place of assembly, shops, a hotel, a conference facility, a restaurant, informal trading and a veterinary practice.
One rule is easy to miss. For any use on GR2 land other than a dwelling house or a second dwelling, vehicle access must come from an adjacent road reserve at least 9 m wide. On a small or awkwardly placed erf, that can rule a scheme out before the coverage figure matters.
Ask the zoning scheme a question
Zonely Chat answers questions about Cape Town zoning, with the answer quoted from the scheme text. Try your GR2 question for free.
Open Zonely ChatThe gap between "GR2 allows it" and "you can build it"
The numbers above are the outer limits the zoning sets. They are not a design, and they say nothing about what is specific to your erf.
- Overlay zones can sit on top of the base zoning. Heritage and environmental overlays are common, and the Incentive Overlay Zoning can change the coverage, height and floor space in designated areas.
- A servitude or a title deed condition can bind your erf whatever the zoning permits.
- The shape and size of the erf matter. The same percentages and metres give very different buildable areas on a regular rectangle and on a sloping or irregular erf.
- If your plan does not fit, a building line relaxation may be possible, but it is an application, not a right.
If you are weighing up a GR2 property, your own or one you want to buy, that erf-specific answer is worth getting before you commission drawings.
Frequently asked questions
What does GR2 mean in Cape Town?
GR2 is General Residential Subzoning 2 in the City of Cape Town's zoning scheme. It allows flats, group housing and other denser housing. For flats, boarding houses and hotels the by-law sets a 60% coverage limit, a floor factor of 1,0 and a 15,0 m height limit.
Is GR2 the same as SR1 or R1?
No. R1 (older records say SR1) is the zoning for a normal house on its own erf. GR2 is a General Residential zoning for denser housing. A single house on a GR2 erf still follows the R1 rules, and group housing follows the GR1 group housing rules.
How many storeys can I build on GR2?
For flats, the height limit is 15,0 m, which is usually four or five storeys. The floor factor of 1,0 may stop you well before that, because it caps total floor area at the erf size. A house follows the R1 height rules instead.
Can I build a second dwelling on a GR2 erf?
Yes. A second dwelling is a primary use on GR2, and the R1 rules for a second dwelling apply to it (items 21(b), 22 and 25A). Building lines, servitudes and title deed conditions still decide whether it fits.
Working out what your GR2 erf can take?
Tell us the address and what you are considering. AB+HvD Architects will read the zoning, overlays and building lines on your erf and give you an honest answer before you spend on plans. Free, no obligation.
Get my free feasibility reviewWe reply personally within one working day.
Related reading:
AB+HvD Architects
An architecture practice working across Cape Town and Knysna. Hanneke van Deemter is the SACAP-registered architect. Zonely is the practice's free property intelligence tool. abarc.co
Related reading
Municipal Valuation Cape Town: How to Check What the City Says Your Property Is Worth
Every Cape Town property has an official municipal valuation that sets your rates bill - and it's rarely the same as market value. Here's how to check it.
Can I Add a Second Storey to My House in Cape Town?
Adding a floor is the go-to move when ground-floor coverage is maxed out - but it opens a different set of rules: height, storey limits, view conditions, and whether your foundations can carry it. Here's how to work out if it's realistic.
Check your own property while you're here
Enter an address for a free read on its zoning, erf size and building lines. Built and checked by AB+HvD Architects.
Run the free check